Volumio app can't find DigiOne after Volumio Shutdown

[frankc23]

When I Shutdown>Power off Volumio, I get the spinning balls that never stop. I'm told this indicates a successful shutdown. Correct?

But why is the app or browser IP address not able to find the device afterwards? Also, when I go to the Settings button on the iOS app start page to view the IP address, it shows “error” after attempting “connecting” for a while.

 

So my question: HOW do I restart Volumio on the Allo DigiOne after a shutdown? Any help is appreciated.

 

Frank

 

My Setup:

-Allo DigiOne Player (RPi 4 with 2GB RAM) with Volumio pre-installed. Brand new.

-Nirvana Power Supply
-Connected to my WIFI (50+mbps speed)
-Assigned a permanent IP address

[stefano_mbp]

26 minutes ago, frankc23 said:

HOW do I restart Volumio on the Allo DigiOne after a shutdown?

Unplug the power cord and plug it in again or, if you have a power switch put off and then on again

[frankc23]

Thanks for responding. 
 

I’ve done that. But when I power the DigiOne back up, giving it 20 minutes to boot up, I still can’t find the device. 
 

Corrupted SD card? Any thoughts on how to proceed?

 

 

 

[stefano_mbp]

4 minutes ago, frankc23 said:

Corrupted SD card?

It’s possible, try to flash it again

[frankc23]

 I flashed another SD card with a fresh Volumio. But when I inserted it, it didn’t work.

 

I placed the original SD card in, and after three or four power shut downs I was able to start up Volumio again. But I feel scared to shut down again!

 

 

 

[stefano_mbp]

9 minutes ago, frankc23 said:

 I flashed another SD card with a fresh Volumio. But when I inserted it, it didn’t work.

Could be a faulty card … on my two rpi4 and one SOtM sMS200 I use only Sandisk Ultra class 10 A1 16GB and never had a single issue

[frankc23]

Both SD cards I have are that same Sandisk Ultra model! Let’s see how things play out

[frankc23]

After all, it must have been a corrupted SD card.

 

I reflashed the card, after which an app shutdown followed by a power-down on the RPi worked well. 

 

Power up the RPi, wait several minutes, then log on. Also worked well.

 

Thanks to all for your help.