Two 2-channel USB DACS into a 2.2 System using Room Correction. Anyone done it?

[ricko01]

A bit late where I am to fully follow exactly what you are doing but it sounds like one of the DEQX products might be what you need.

 

They have various processors but all provide preamp/dac/eq functions with multiple digital and analogue outs for different "zones".

 

The processors support two or three zones and you can configure each as needed.

 

They are well reviewed and I use an HDP-4 for a four channel (all full range) system (noting its 2 channel IN, four channel out)

 

see: https://www.deqx.com/

 

Peter

 

[ricko01]

5 hours ago, cjf said:

Hello and thanks for the link.

 

In the past I looked into Deqx products but last time I looked they only do 24/96..like most similar units. This is one reason why I went Audiolense in the computer world to do corrections for higher sample rate music without down sampling.

 

Was true. Their most recent products (shown below) support high bit rates and ROON. The pre-mate has two analogue outs, the HDP-5 has three.

 

 

We see that either supports the following (all PCM based, no DSD)

 

 

 

[ricko01]

1 hour ago, ricko01 said:

 

last time I looked they only do 24/96..

 

 

 

however you may be right... that internally its all 24/96... I will check on this

[ricko01]

4 minutes ago, ricko01 said:

 

 

however you may be right... that internally its all 24/96... I will check on this

 

yep... the digital outs are all limited to 96k.... which points to an internal max of 24/96.

 

not a concern for me