Jump to content
rickca

New HDPLEX 200W LPS

Rate this topic

Recommended Posts

I have an HDplex on the way. Which output would be best for my NUC 7i7DNBE ?

Share this post


Link to post
Share on other sites
11 hours ago, lmitche said:

Yes, and if you can try an lps1.2 set at 12 volts. Musicality is off the charts listening to NUCs powered with an lps1.2! Either of the fixed Hdplex 200 outputs make good energizing sources for an Lps1.2.

 thanks for the replies.

Does the lps1.2 have enough power to run a NUC? looking at the spec it seems to only provide 1.1 amps.

Share this post


Link to post
Share on other sites

Anyone tried a fuse upgrade in the hdplex 200 - such as a SR blue?

looks like a 6.3amp fast blow, the marking is a bit indistinct.

Share this post


Link to post
Share on other sites
12 hours ago, octaviars said:

I hope to get my new PSU tomorrow (replacing the old 200W) anyone here using all four outputs on it with modest loads (NUC, router, switch etc.) and how hot does it get? 

 

I have all 4 connected running my; 19v i3 itx server,  12v router, 5v ssd, and 9v switch at the moment - it does get pretty warm, I leave it on all the time except that I turn off the server supply when when not listening, it is just slightly warm then. Am  awaiting another LPS to do 19v duties. I have had the unit over 2 months.

Share this post


Link to post
Share on other sites

×
×
  • Create New...