Python for OLED display

[TMMASLAR]

The display on my Boss 2 is blank. I have tried to download the Python based file. I got as far as the "./install_boss2_oled.sh" command. I am getting a "Command not Found" error.

I have attached screenshots of where I am stuck below.

[AlloSupp_N]

in the latest Dietpi OS releases no need to install manually.

 

refer below link

http://3.230.113.73:9011/Allocom/Boss2/Dietpi/dietpi-config-boss2-oled.pdf

 

[TMMASLAR]

I updated DietPi to v8.6.1

 

I also did the OLED display configuration shown in the above PDF document.

 

Now the OLED dispay is displaying "NO BOSS2"

 

I am not getting any audio output using ROON from the RCA jacks on the BOSS2.

 

I am using the BOSS2 as a ROON endpoint.

 

On my ROON Audio tab it is showing 3 DietPi devices.

 

ROON DietPi

192.168.2.42

 

bcm2835 HDMI 1

ALSA

bcm2835 Headphones

ALSA

 

Other Network Devices

DietPi (Shairport Sync)

Via Airplay, 192.168.2.42

 

 

 

[AlloSupp_N]

Allo GUI , Audio device need to configure for Allo Boss2 , save changes and then reboot.

[TMMASLAR]

18 minutes ago, AlloSupp_N said:

Allo GUI , Audio device need to configure for Allo Boss2 , save changes and then reboot.

13 hours ago, AlloSupp_N said:

in the latest Dietpi OS releases no need to install manually.

 

refer below link

http://3.230.113.73:9011/Allocom/Boss2/Dietpi/dietpi-config-boss2-oled.pdf

 

I did reboot last night using DietPi interface.  When I try to reboot from the Allo web interface I just get a continuous spinny circle. I just did hard reboot again by powering down the BOSS2 and RP4. Same thing on display "NO BOSS2". Can I somehow verify that the OLED configuration is indeed installed?

[TMMASLAR]

I did save changes last night on the DietPi interface. How can I verify that the OLED configuration has been properly installed?