Boss 2 instructions

[reprap]

Hi I recently purchased a Boss2 in an acrylic case.
It came with no instructions about how to install it with a Pi4b.
Can you post me instructions with pictures for single and dual powering.
It has a floating power lead.  Where does this connect to?
I have a Nirvana power supply.
Thanks.

[Audio_Allo]

3 hours ago, reprap said:

Hi I recently purchased a Boss2 in an acrylic case.
It came with no instructions about how to install it with a Pi4b.
Can you post me instructions with pictures for single and dual powering.
It has a floating power lead.  Where does this connect to?
I have a Nirvana power supply.
Thanks.

We have to assemble Boss 2 acrylic with RPI 4's 40 PIN connector . Only need to place  Boss 2 acrylic on top RPI 4's 40 pin connector.

 

 

And then need to insert OS loaded SD card to RPI's SD card slot ,then connect ethernet cable from your router to RPI's ethernet port ,and connect Boss 2 output to your DAC/AMP .

 

Then power ON the player by connecting nirvana power supply  to Boss 2 player's DC in connector.

 

 

After the complete boot ,scan your network for finding the IP address detected by the device.

 

Then enter the same IP address in your PC web browser for accessing the plaer GUI.

 

Then select audio output device as All Boss 2 and reboot the player