Jesal Posted May 12, 2018 Share Posted May 12, 2018 Hi @mitchco just want to say thanks I'm starting on this exciting DRC journey because of your articles. I think I understand what needs to be done on Audiolense side of things. I'm a bit confused on what needs to be done in JRiver side, besides adding the convolver. Do I need to do routing in JRiver too? Sorry for the basic question, I'm new to Audiolense and JRiver. I did some research and I believe I need a 2 channel in a 5.1 container? and routing of 6 channels in PEQ? Just getting more confused as I read more... I think I have step 2 and 3 but missing step 1 it's time to ask for help. My plan is to use JRiver/AudiolenseXO and Lynx2B for a 3 way active setup. Thanks again for your articles and help. Link to comment
Jesal Posted May 12, 2018 Share Posted May 12, 2018 Thanks a lot Mitch, spent a few hours on this following your instructions. After a 2-3 hair pulling sessions i managed to get all channels routed and measured. Feeling a sense of accomplishment that I've gotten this far. Just a couple of issues to sort out. 1. I only managed to measure once, I ran the Measurement the second time and I keep getting a device not available error. 2. My umik1 has a very loud feedback when plugged in. No issues with my blue yeti Mic. Step 1 accomplished, thanks to you mitchco 1 Link to comment
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now