Jump to content
IGNORED

JCAT USB XE and AudioLinux/Euphony


Recommended Posts

 

7 minutes ago, Marcin_gps said:

Yes! Piero agreed to test it. We will ship the board to him for evaluation tomorrow.

 

Best regards,
Marcin 

Is this for testing to allow Z590/Z690 motherboards with an AudioLinux OS to use the USB XE card without a firmware update?

 

Link to comment
  • 8 months later...
1 hour ago, Johnseye said:

Has anyone been able to get this card to work with Euphony? 

Yes it works fine

Doepke DFS2/ Gigawatt C16A + 044/ Lc-y Evo/ LC3-EVO /LC2-Evo/ LC-3 MK3/ Toroidy DC Blocker/ Hdplex H5 / Windows 10 Pro1903 AO3 + Fidelizer Pro 8.10/ JPLAY Femto/ Crosshair VIII Dark Hero/ Ryzen 9 5950X/ Optane P1600X/ Apacer 2x4GB DDR4 ECC 2666/ Jcat Usb XE/ Jcat Net XE /Audiowise Opto USB/ Sablon USB Evo/ 2x Paul Hynes SR4T for Jcat / 2x Baaske NET Isolator MI 1005/ Ethernet cable Viablue EP-7S/ Sablon Ethernet 2020 /Fidelizer StreamHub/ All Dc cables Neotech Occ JSSG360 /Hdplex 500W DC ATX/ Holo Spring 3 KTE/ Audio Research LS5 (4x E188CC Red Label/ 4x RCA 12BH7A Black Plates/ 2X Brimar 12BH7 Black Plates)/ Proceed HPA2 (Mark Levinson 432)/ Scansonic MB 3.5B + Iso Acoustics Gaia III / Townshend Isolda EDCT/ 2x Townshend DCT 300 XLR/ Synergistic Research Purple Fuses In Hdplex, 2x SR4T, Preamp, Dac/ 4X Townshend Seismic Pods

Link to comment
  • 2 months later...

Has anyone successfully run the JCAT USB CARD XE on the new Euphony Verison 4?

 

There are problems on a MB with chipset Z390. The USB ports from the motherboard work fine.

Link to comment
17 minutes ago, StreamFidelity said:

Has anyone successfully run the JCAT USB CARD XE on the new Euphony Verison 4?

 

There are problems on a MB with chipset Z390. The USB ports from the motherboard work fine.

 

The only problem I've had with that card and Euphony is that upsampling to PCM 1.5M produces static.  It's not the card as it works fine via HQPlayer direct and with Windows.  The same issue is experienced with both Euphony and Audiolinux.  PCM 768 and below works fine.

Link to comment

Thank all very much for the quick answers. Now it runs here too. There was a problem when inserting the card into the motherboard. Probably not all pins were connected.

Link to comment

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



×
×
  • Create New...