Jump to content

Shanti + DigiOne Signature configuration help please!


Recommended Posts

Just received my Shanti power supply but it didn’t come with documentation and I haven’t been able to find any online.  Can someone advise me on setting it up to work with my DigitOne Signature?  Which power outs (5V 3A, 5V 1A) go to the “clean” side and which to the “dirty”?  Also, there is what looks like a ground(?) next to the on/off switch.  What are best practices for the ground?  

Link to post
Share on other sites
11 minutes ago, Bill_NYC said:

Just received my Shanti power supply but it didn’t come with documentation and I haven’t been able to find any online.  Can someone advise me on setting it up to work with my DigitOne Signature?  Which power outs (5V 3A, 5V 1A) go to the “clean” side and which to the “dirty”?  Also, there is what looks like a ground(?) next to the on/off switch.  What are best practices for the ground?  

Forwarded PM please check

Link to post
Share on other sites

Or just plug them both in (as noted two posts up) and power up. Booting the RPI takes much longer than initialising the WM chip, so all is good. 
 

PS done this many times without issue.

Link to post
Share on other sites


×
×
  • Create New...