Jump to content
IGNORED

Article: A New Listening Room Part Two: Acoustics, Speakers, DSP


Recommended Posts

I have a really dumb question. With DSP, why does one need treatments? Can’t everything be done by DSP?

- Mark

 

Synology DS916+ > SoTM dCBL-CAT7 > Netgear switch > SoTM dCBL-CAT7 > dCS Vivaldi Upsampler (Nordost Valhalla 2 power cord) > Nordost Valhalla 2 Dual 110 Ohm AES/EBU > dCS Vivaldi DAC (David Elrod Statement Gold power cord) > Nordost Valhalla 2 xlr > Absolare Passion preamp (Nordost Valhalla 2 power cord) > Nordost Valhalla 2 xlr > VTL MB-450 III (Shunyata King Cobra CX power cords) > Nordost Valhalla 2 speaker > Kaiser Kaewero Classic /JL Audio F110 (Wireworld Platinum power cord).

 

Power Conditioning: Entreq Olympus Tellus grounding (AC, preamp and dac) / Shunyata Hydra Triton + Typhoon (Shunyata Anaconda ZiTron umbilical/Shunyata King Cobra CX power cord) > Furutec GTX D-Rhodium AC outlet.

Link to comment
6 hours ago, mitchco said:

 

Mark, not a dumb question. DSP can't absorb or diffuse the sound in a room. So if your room sounds like a bare room echo chamber, DSP can't attenuate the echo or long sound decay at higher frequencies. You need absorption and sometimes a combo of absorption and diffusion. DSP can manipulate the frequency response including the room plus loudspeakers at lower frequencies and just the loudspeaker's direct sound at higher frequencies. DSP can be used for digital crossovers, time alignment of drivers, excess phase correction and the list goes on. DSP can also reduce low frequency room resonances.

 

For living rooms that are fully furnished, drapes, carpet, book cases, etc., it is likely that the rooms decay time falls within the spec as there is a range of operation. So in those cases, acoustic treatments are not likley required.

Hope that helps.


yes, thanks for explaining this. 

- Mark

 

Synology DS916+ > SoTM dCBL-CAT7 > Netgear switch > SoTM dCBL-CAT7 > dCS Vivaldi Upsampler (Nordost Valhalla 2 power cord) > Nordost Valhalla 2 Dual 110 Ohm AES/EBU > dCS Vivaldi DAC (David Elrod Statement Gold power cord) > Nordost Valhalla 2 xlr > Absolare Passion preamp (Nordost Valhalla 2 power cord) > Nordost Valhalla 2 xlr > VTL MB-450 III (Shunyata King Cobra CX power cords) > Nordost Valhalla 2 speaker > Kaiser Kaewero Classic /JL Audio F110 (Wireworld Platinum power cord).

 

Power Conditioning: Entreq Olympus Tellus grounding (AC, preamp and dac) / Shunyata Hydra Triton + Typhoon (Shunyata Anaconda ZiTron umbilical/Shunyata King Cobra CX power cord) > Furutec GTX D-Rhodium AC outlet.

Link to comment

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



×
×
  • Create New...