EtherREGEN: The long development thread. [Some Gen2 dev. pics and update starting on page 92.]

[Middy]

Have a great time all at Uptone .

Happy Xmas 

[Middy]

If you have hand press or fly press  you could make a simple holder to dispense the 2 part into a dish. / On a HSink

 

1. Pushing rods Tapped mild steel rods in a plate. Or a simple small wooden block with 2 dowels screwed in. Slightly longer than the syringe..

 

2.Base is just a block to hold the dual syringes. (Drill 2 holes)

4 off feet to raise it off the plate so a mixing tray can fit underneath. Or an upside down heatsink... cocktail stick mix and fit.

Fancy systems use pneumatic or worm screws. 

So...

2 blocks of wood and a length of Dowling.  A drill and 6 screws

If you have press handy....?

And a happy assistant who wont crush your hand as you wish her happy holidays..

 

More an excuse to wish you all luck, been lovely watching this take shape.

Have a lovely break.

Kind regards

Dave 

 

PS if in the picture they are black anodised blocks, cutting up the clear trays make free mixing trays....

[Middy]

Just put the screw driver in the fridge before undoing them..

[Middy]

Sorry a little apprentice engineer humour with a hint of truth....i nearly suggested 2 cans of WD40 and an ice bath but the angry

E-mail from your assistant about the new returns she is getting..... simple trick keep the tx square then a light tap on top. Drives the shaft down a touch and breaks the alu thread- coated screw bond....or just wait til its cool...  going down the helpful rabbit hole sorry Alex.... 

Why are there no Dr Audiophiles...

They have no patients....

[Middy]

A lead roof has better EMI and vibration properties..

Happy holidays USA people..