Equipment isolation and vibration damping.

[completeluxury]

a lot of the talk in this thread is completely over my head, but one probably very stupid question i have about the set just posted.

 

its 6 bases and 3 balls.. is it 1 base per support on each device? for instance most amps have 4 feet, so you replace each of those with one of the bases? or is it a top and a bottom and then a ball to go in the middle?

[completeluxury]

what about with speakers? obviously just sitting on 3 balls or even a flat surface on top of 3 balls wouldnt be great if something were to knock it... like my 6 month old nephew!

[completeluxury]

unfortunately i dont have a listening room, my setup is in the living room. even if its more stable than anticipated i dont think i could leave it and not worry constantly.

 

the equipment side would be fine though... nobody touches my equipment but me or death ensues.

 

if his group buy is 6 feet and 3 bearings, perhaps you should ask to have the price adjusted for 6 feet and 6 bearings?

[completeluxury]

barry, i saw a post that you deleted, yesterday i think, about your design for a cup and ball isolator.

 

by any chance have you, or will you, share your design with the people for the group buy?

[completeluxury]

Despite most of that HRS stuff being well out of my price range i wonder how these would go.

 

Nimbus System

 

they are well priced and they say it works on any shelf system so it might be a replacement for the cup and ball?